Makerbot Digitizer Teardown

crwdns2935423:0crwdne2935423:0

crwdns2935425:01crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936323:0crwdne2936323:0

crwdns2931653:01crwdne2931653:0

Makerbot Digitizer Teardown, Remove rear screws and face plate: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

Makerbot Digitizer Teardown, Remove rear screws and face plate: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

Makerbot Digitizer Teardown, Remove rear screws and face plate: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Remove rear screws and face plate

There are four black T15 screws that hold the front panel on.
Do not confuse these with the two laser adjustment screws.
The ones you need to loosen are perpendicular with the frame; not angled.
Once the screws are loosened, the front panel simply pulls off.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0