crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

기본 LED 손전등 DIY 납땜 키트 어셈블리

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936325:0crwdne2936325:0
crwdns2931653:025crwdne2931653:0
Basic LED Flashlight DIY Soldering Kit Assembly, Trim the leads: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Basic LED Flashlight DIY Soldering Kit Assembly, Trim the leads: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Basic LED Flashlight DIY Soldering Kit Assembly, Trim the leads: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Trim the leads

  • Use your flush cutters to trim all the leads until they're no longer poking up past the solder joint from the back of the board.

  • Ensure that none of the wires are long enough to bridge a connection to other leads or poke your hands during use.

  • This is a great time to clean up any residue left from the solder. Apply some isopropyl alcohol to the solder joints and wipe with a lint-free cloth to soak up the flux and alcohol residue.

리드 다듬기

플러시 커터를 사용하여 모든 리드가 기판 뒷면에서 납땜 조인트를 넘어 더 이상 돌출되지 않을 때까지 다듬으세요.

전선이 다른 리드에 연결되거나 사용 중에 손을 찌를 정도로 길지 않은지 확인하세요.

이제 납땜에 남은 잔여물을 청소하기에 좋은 때입니다. 납땜 조인트에 이소프로필 알코올을 약간 바르고 보풀이 없는 천으로 닦아 플럭스와 알코올 잔여물을 흡수하세요.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0