crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Kit soldadura de bricolaje para linternas LED básicas

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:013crwdne2931653:0
Basic LED Flashlight DIY Soldering Kit Assembly, Flip the board over: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Basic LED Flashlight DIY Soldering Kit Assembly, Flip the board over: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Basic LED Flashlight DIY Soldering Kit Assembly, Flip the board over: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Flip the board over

  • Hold the battery connector flush against the front of the circuit board.

  • Flip the board over and set it down so the battery connector is resting on your work mat or surface.

  • Place the foam block underneath the top edge of the board (the edge with the notch) to keep it level while you solder.

Dale la vuelta a la placa

Sujeta el conector de batería a ras de la parte frontal de la placa de circuito.

Dale la vuelta a la placa y colócala de modo que el conector de batería descanse sobre tu esterilla o superficie de trabajo.

Coloca el bloque de espuma debajo del borde superior de la placa (el borde con la muesca) para mantenerla nivelada mientras tu sueldas.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0