crwdns2933423:0crwdne2933423:0

Roborock S7 Laser-Abstandssensor tauschen

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:08crwdne2931653:0
Roborock S7: Laser Distance Sensor Replacement, Remove the motor.: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Roborock S7: Laser Distance Sensor Replacement, Remove the motor.: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Roborock S7: Laser Distance Sensor Replacement, Remove the motor.: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Remove the motor.
  • These screws are very easy to strip. Maintain good downward pressure and turn slowly.

  • Remove the screws. Use a PH #00 precision screwdriver.

  • If your motor is soldered onto LDS PCBA and you haven't de-soldered it, slowly and carefully, slide it out.

Diese Schrauben können leicht beschädigt werden. Drücke fest nach unten drehe langsam.

Nimm einen Kreuzschlitzschraubendreher #00 und entferne die Schrauben.

Wenn dein Motor an der Platine des LDS festgelötet ist und du hast ihn noch nicht entlötet, dann schiebe ihn langsam und sorgfältig heraus.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0