crwdns2933423:0crwdne2933423:0

Roborock S7: Laser Distance Sensor Replacement

crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:05crwdne2931653:0
Roborock S7: Laser Distance Sensor Replacement, Removing the LDS.: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Roborock S7: Laser Distance Sensor Replacement, Removing the LDS.: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Roborock S7: Laser Distance Sensor Replacement, Removing the LDS.: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Removing the LDS.
  • Remove the four marked screws.

  • Then, much like the cage, simply lift the LDS out of the slot.

  • One iteration of the LDS is smaller in size and is connected to the motherboard via cable connector. You will also see 8 screws, simply unscrew the inner 4, then lift it slowly, until you can flip it over and detach the connector.

  • If you have an LDS replacement, simply insert your new LDS and close the device up.

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0