Oscal Tiger 12: Teardown

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936311:0crwdne2936311:0

crwdns2931653:01crwdne2931653:0

Heating

Begin by heating the back panel (where the cameras are).
I use a heating pad set to 100 Celsius for this job. Usually put it on before it's heated, then let it sit 6-7 minutes at 100.
You can use a heat gun instead. Just make sure to heat all the surfaces enough. How much enough is, you will have to find out.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0