Roborock S7: Teardown

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2935421:0crwdne2935421:0 crwdns2935423:0crwdne2935423:0

crwdns2935425:02crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936321:0crwdne2936321:0

crwdns2931653:02crwdne2931653:0

Roborock S7: Teardown, LiDAR: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

Roborock S7: Teardown, LiDAR: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

Roborock S7: Teardown, LiDAR: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

LiDAR

Remove the rubber caps covering the 2 screws.
Remove the screws.
Remove the LiDAR cage.
Remove the LiDAR screws, then remove the LiDAR.
Based on the version of the robot, you might see one of 3 different iterations of the LiDAR. One, that is noticeably smaller, is connected via cable, whereas the other 2 are simply connected by a connector.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0