Cricut Maker 3 Rubber Rollers Replacement

crwdns2935425:012crwdne2935425:0

crwdns2936315:0crwdne2936315:0

crwdns2936321:0crwdne2936321:0

crwdns2931653:012crwdne2931653:0

Be careful when removing the E‑clip in this step so you don't lose it.
Insert a small flathead screwdriver or similar prying tool into one of the notches of the E‑clip that secures the roller bar.
Use the screwdriver or prying tool to pry the E‑clip off the roller bar.
You can place your thumb or a small piece of tape over the clip to keep it from flying away.
During reassembly, you can hold the E‑clip in place with a small piece of tape then use a pair of needle nose pliers to squeeze the clip onto the roller bar.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0