Roborock S8 MaxV Ultra: Teardown

crwdns2935421:0crwdne2935421:0

crwdns2935425:09crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936313:0crwdne2936313:0

crwdns2931653:09crwdne2931653:0

Roborock S8 MaxV Ultra: Teardown, Removing the VibraRise module: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

Roborock S8 MaxV Ultra: Teardown, Removing the VibraRise module: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

Roborock S8 MaxV Ultra: Teardown, Removing the VibraRise module: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Removing the VibraRise module

First, disconnect the connector from the motherboard.
Do be gentle doing this. I've broken the connector on the motherboard before.
Get the cable out of the housing and through the hole indicated by the arrow.
Flip it over, then get the wire out of the housing. Use your tweezers for this.
Flip it over again, then detach the pipe from the water tank.
The VibraRise is still loosely held in place by 2 latches on the left and right sides.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0