crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Extracción de la placa lógica

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:06crwdne2931653:0
Logic Board Removal, Remove the logic board screw: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Logic Board Removal, Remove the logic board screw: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Logic Board Removal, Remove the logic board screw: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Remove the logic board screw

  • Use a standoff screwdriver to remove the 4.8 mm‑long standoff screw from the bottom right corner of the logic board.

  • If you don't have a standoff screwdriver, you can use a flathead screwdriver that's as wide as (or slightly wider than) the screw. To avoid stripping, make sure the driver is properly aligned with the screw and apply continuous downward pressure.

Quita el tornillo de la placa lógica

Usa un destornillador para quitar el tornillo de 4,8 mm de largo de la esquina inferior derecha de la placa lógica.

Si no tienes un destornillador, puedes usar un destornillador de punta plana que sea tan ancho como el tornillo (o un poco más ancho). Para evitar que se descascare, asegúrate de que el destornillador esté correctamente alineado con el tornillo y aplica presión continua hacia abajo.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0