crwdns2933423:0crwdne2933423:0

Sostituzione/aggiornamento processori Mac Pro (inizio 2008)

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:07crwdne2931653:0
Replacing/Upgrading Mac Pro Processors (Early 2008), Replacement Note: Existing Heatsink: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
Replacement Note: Existing Heatsink
  • Perform the following steps once you have installed the new processors and ready to re-install the heatsinks.

  • Preparing an EXISTING Heatsink for Re-installation. If you have a new heatsink, follow the NEW Heatsink procedure.

  • Using the alcohol pad included with the logic board or processor replacement part, clean off any used thermal grease from the processor and the bottom of the heatsink.

  • Using the thermal grease included with the logic board or processor replacement part, apply one dot of fresh grease to the raised square area on the bottom of the heatsink.

  • Spread the grease evenly across the square to a thickness of approximately 1 mm.

  • Warning: Do not apply more grease than recommended. The grease must not overflow the heatsink and come in contact with the processor connector.

Esegui i passaggi seguenti una volta installati i nuovi processori e pronti a reinstallare i dissipatori di calore.

Preparazione di un dissipatore di calore ESISTENTE per la reinstallazione. Se si dispone di un nuovo dissipatore di calore, segui la procedura NUOVO dissipatore di calore.

Usando il tampone imbevuto di alcol incluso con la scheda logica o con la parte di ricambio del processore, pulisci eventuali residui di grasso termico usato dal processore e dal fondo del dissipatore di calore.

Usando il grasso termico incluso con la scheda logica o la parte di ricambio del processore, applica un punto di grasso fresco sull'area quadrata rialzata sul fondo del dissipatore di calore.

Distribuisci in modo uniforme il grasso sul quadrato fino ad uno spessore di circa 1 mm.

Attenzione: Non applicare più grasso di quanto necessario. Il grasso non deve traboccare dal dissipatore di calore ed entrare in contatto con il connettore del processore.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0