crwdns2933423:0crwdne2933423:0

Instalación de Briggs y Stratton - Reparación del desequilibrio de la batería

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:04crwdne2931653:0
Briggs and Stratton instart - Battery imbalance repair, Charge cells to same voltage: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
Charge cells to same voltage
  • Charge each cell to the highest individual cell voltage (no need to fully charge all of them)

  • Set power supply to 4.1V and limit current to 750mA. 750mA is the standard charging current for a LGDAHB21865 cell. If the battery has different cell type, the datasheet needs to be checked first.

  • Important: Do not exceed cell type rated charging voltage or current. Refer datasheet.

  • Connect the power supply to the terminals of the individual cell and charge until terminal voltage reached. Make sure polarity is correct (positive to positive and negative to negative). Observe the charging procedure at all time.

  • Important: Individual cells are not protected against reversed polarity. Wrong polarity will kill the cell.

  • Note: If battery cell is not charging the cell might be dead. Don't continue charging and consider replacing the cells or recycle the battery.

  • At the end of the charging procedure verify each cell has same voltage using the multimeter (+/- 0.01V). Note that cell voltage provided on the power supply unit might not be the same when measured with the multimeter.

Carga cada celda al voltaje de celda individual más alto (no es necesario cargarlas todas por completo)

Configura la fuente de alimentación a 4,1 V y limita la corriente a 750 mA. 750 mA es la corriente de carga estándar para una celda LGDAHB21865. Si la batería tiene un tipo de celda diferente, primero se debe verificar la hoja de especificaciones.

Importante: No excede el voltaje o la corriente de carga nominal del tipo de celda. Consulta la hoja de especificaciones.

Conecta la fuente de alimentación a los terminales de la celda individual y cárgala hasta alcanzar el voltaje del terminal. Asegúrate de que la polaridad sea correcta (positiva a positiva y negativa a negativa). Observa el procedimiento de carga en todo momento.

Importante: Las celdas individuales no están protegidas contra polaridad invertida. Una polaridad incorrecta matará la célula.

Nota: Si la celda de la batería no se carga, es posible que esté agotada. No continúes cargando y considera reemplazar las celdas o reciclar la batería.

Al final del procedimiento de carga, verifica que cada celda tenga el mismo voltaje usando el multímetro (+/- 0.01V). Ten en cuenta que el voltaje de la celda proporcionado en la unidad de fuente de alimentación puede no ser el mismo cuando se mide con el multímetro.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0