crwdns2933423:0crwdne2933423:0

Logitech MX Master 3S obere Gehäuseschale tauschen

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:01crwdne2931653:0
Logitech MX Master 3S Top Shell Replacement, Disconnect the horizontal scroll wheel assembly: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Logitech MX Master 3S Top Shell Replacement, Disconnect the horizontal scroll wheel assembly: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Logitech MX Master 3S Top Shell Replacement, Disconnect the horizontal scroll wheel assembly: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Disconnect the horizontal scroll wheel assembly
  • Lay the top shell upside down on your work surface.

  • Use the flat end of a spudger to push out the plastic latch on the connector near the right side of the shell.

  • You should feel the latch pop into the unlocked position. Don't push too far, or the latch may come completely off the connector.

  • Use tweezers or your fingers to gently pull the cable straight up and out of its socket.

  • The cable should come out easily. If you feel any resistance, push the latch out a little more and try again.

Lege die obere Gehäuseschale mit der Oberseite nach unten auf deine Arbeitsfläche.

Drücke mit dem flachen Ende eines Spudgers den Kunststoffriegel am Stecker nahe der rechten Seite der Gehäuseschale heraus.

Du solltest spüren, wie der Riegel in die entriegelte Position springt. Drücke nicht zu weit, da sich der Riegel sonst vollständig vom Stecker lösen könnte.

Ziehe das Kabel vorsichtig mit einer Pinzette oder deinen Fingern gerade nach oben aus seinem Anschluss heraus.

Das Kabel sollte sich leicht herausziehen lassen. Wenn du einen Widerstand spürst, drücke die Verriegelung noch etwas weiter heraus und versuche es erneut.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0