crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Reemplazo de la placa de carga del HMD Pulse Pro

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:016crwdnd2931529:0crwdne2931529:0

crwdns2935423:0crwdne2935423:0

crwdns2935425:01crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:01crwdne2931653:0
HMD Pulse Pro Charging Board Replacement, Remove the charging board cover: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 HMD Pulse Pro Charging Board Replacement, Remove the charging board cover: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Remove the charging board cover

  • Be very careful not to puncture the battery with your screwdriver.

  • Use a Phillips screwdriver to remove the seven 3.6 mm‑long screws securing the charging board cover.

  • The screw near the center of the bottom edge is covered by a sticker. Pierce through it with your screwdriver, or use tweezers to remove it.

Quita la tapa de la placa de carga

Ten mucho cuidado de no pinchar la batería con el destornillador.

Utiliza un destornillador Phillips para quitar los siete tornillos de 3,6 mm de longitud que sujetan la tapa de la placa de carga.

El tornillo situado cerca del centro del borde inferior está cubierto por una pegatina. Pínchalo con el destornillador o utiliza unas pinzas para quitarlo.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0