crwdns2933423:0crwdne2933423:0

Kobo Libra Colour Motherboard tauschen

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:03crwdne2931653:0
Kobo Libra Colour Motherboard Replacement, Disconnect the interconnect cable: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Kobo Libra Colour Motherboard Replacement, Disconnect the interconnect cable: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Kobo Libra Colour Motherboard Replacement, Disconnect the interconnect cable: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Disconnect the interconnect cable
  • Use the tip of a spudger to lift up the locking tab on the ZIF connector.

  • Use tweezers, or your fingers, to grip the blue pull tab on the interconnect cable and disconnect it.

  • During reassembly:

  • Inspect the ends of the cable and the ZIF connectors for any remaining coating that could prevent a good connection.

  • Peel off the coating, heating the cable and the ZIF connector when the coating becomes too brittle.

  • It doesn't have to look pretty! You just need to remove enough coating to have the cable sit properly in the connector.

Hebe den Sicherungsbügel am ZIF-Stecker mit der Spudgerspitze hoch.

Benutze eine Pinzette oder deine Finger, um die blaue Zuglasche am Verbindungskabel zu fassen und es abzutrennen.

Achte beim Wiederzusammenbau auf folgende Punkte:

Prüfe die Kabelenden und die ZIF-Stecker auf eventuelle Beschichtungsreste, die eine gute Verbindung verhindern könnten.

Ziehe die Beschichtung ab, erwärme das Kabel und den ZIF-Stecker, wenn die Beschichtung zu spröde wird.

Es muss nicht schön aussehen! Du musst nur so viel Beschichtung entfernen, dass das Kabel richtig in ihren Steckern sitzt.

[title] Disconnect the interconnect cable
[* black] Use the tip of a spudger to lift up the locking tab on the ZIF connector.
-[* black] Use tweezers, or your fingers, to grip the blue pull tab on the interconnect cable and disconnect it.
+[* black] Use [product|IF145-020|tweezers], or your fingers, to grip the blue pull tab on the interconnect cable and disconnect it.
[* icon_reminder] During reassembly:
[* black] Inspect the ends of the cable and the ZIF connectors for any remaining coating that could prevent a good connection.
[* black] Peel off the coating, heating the cable and the ZIF connector when the coating becomes too brittle.
[* icon_note] It doesn't have to look pretty! You just need to remove enough coating to have the cable sit properly in the connector.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0