crwdns2933423:0crwdne2933423:0

断开主板连接

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:06crwdne2931653:0
Motherboard Disconnection: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Motherboard Disconnection: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Motherboard Disconnection: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
  • Because of the awkward angle, this step requires some patience to avoid tearing the cables. Work slowly and apply heat regularly.

  • Use blunt nose tweezers to pull the cables away from their ZIF connectors slowly and steadily at a level angle to separate the coating.

  • Gripping the tweezers closer to the tip can help get a tighter hold on the cables.

  • Keep pulling on the cables until they're completely disconnected.

  • During reassembly:

  • Inspect the ends of the cables and the ZIF connectors for any remaining coating that could prevent a good connection.

  • Peel off the coating, heating the cable and the ZIF connectors when the coating becomes too brittle.

  • It doesn't have to look pretty! You just need to remove enough coating to have the cables sit properly in their connectors.

由于角度不佳,这一步骤需要一些耐心,以免撕裂排线。操作时要缓慢,并定期加热。

使用钝头镊子以水平角度缓慢而稳定地将排线从 ZIF 接口上拉开,以分离涂层。

将镊子靠近尖端握住可以帮助更紧地固定排线。

继续拉排线,直到完全断开。

在重新组装过程中:

检查排线和 ZIF 接口的末端是否有任何残留涂层,以免影响连接。

剥离涂层,在涂层变得太脆时加热排线和 ZIF 接口。

不一定要追求完美!您只需去除足够的涂层,让排线正确地插入接口即可。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0