crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

마더보드 연결 해제

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936325:0crwdne2936325:0
crwdns2931653:06crwdne2931653:0
Motherboard Disconnection: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Motherboard Disconnection: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Motherboard Disconnection: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

  • Because of the awkward angle, this step requires some patience to avoid tearing the cables. Work slowly and apply heat regularly.

  • Use blunt nose tweezers to pull the cables away from their ZIF connectors slowly and steadily at a level angle to separate the coating.

  • Gripping the tweezers closer to the tip can help get a tighter hold on the cables.

  • Keep pulling on the cables until they're completely disconnected.

  • During reassembly:

  • Inspect the ends of the cables and the ZIF connectors for any remaining coating that could prevent a good connection.

  • Peel off the coating, heating the cable and the ZIF connectors when the coating becomes too brittle.

  • It doesn't have to look pretty! You just need to remove enough coating to have the cables sit properly in their connectors.

이 단계는 어색한 각도로 인해 케이블이 찢어지지 않도록 약간의 인내심이 필요합니다. 천천히 작업하고 규칙적으로 열을 가하세요.

무딘 핀셋을 사용하여 케이블을 ZIF 커넥터에서 천천히 일정한 각도로 잡아당겨 코팅을 분리하세요.

핀셋의 끝 부분에 더 가깝게 잡으면 케이블을 더 꽉 잡는 데 도움이 됩니다.

케이블이 완전히 분리될 때까지 계속 당기세요.

재조립할 떄:

케이블 끝과 ZIF 커넥터에 원활한 연결을 방해할 수 있는 코팅이 남아 있는지 검사하세요.

코팅이 너무 부스러지면 케이블과 ZIF 커넥터를 가열하여 코팅을 벗겨내세요.

예쁘게 보일 필요는 없습니다! 케이블이 커넥터에 제대로 장착될 수 있을 만큼만 코팅을 벗겨내면 됩니다.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0