crwdns2933423:0crwdne2933423:0

Desconexión de la placa madre

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:06crwdne2931653:0
Motherboard Disconnection: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Motherboard Disconnection: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Motherboard Disconnection: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
  • Because of the awkward angle, this step requires some patience to avoid tearing the cables. Work slowly and apply heat regularly.

  • Use blunt nose tweezers to pull the cables away from their ZIF connectors slowly and steadily at a level angle to separate the coating.

  • Gripping the tweezers closer to the tip can help get a tighter hold on the cables.

  • Keep pulling on the cables until they're completely disconnected.

  • During reassembly:

  • Inspect the ends of the cables and the ZIF connectors for any remaining coating that could prevent a good connection.

  • Peel off the coating, heating the cable and the ZIF connectors when the coating becomes too brittle.

  • It doesn't have to look pretty! You just need to remove enough coating to have the cables sit properly in their connectors.

Debido al incómodo ángulo, este paso requiere algo de paciencia para evitar desgarrar los cables. Trabaja despacio y aplica calor regularmente.

Utiliza pinzas de punta roma para separar los cables de sus conectores ZIF despacio y con firmeza, en un ángulo nivelado, para separar el revestimiento.

Agarrar las pinzas más cerca de la punta puede ayudar a sujetar mejor los cables.

Sigue tirando de los cables hasta que estén completamente desconectados.

Durante el reensamblaje:

Inspecciona los extremos de los cables y los conectores ZIF en busca de restos de revestimiento que pudieran impedir una buena conexión.

Despega el revestimiento, calentando el cable y los conectores ZIF cuando el revestimiento se vuelva demasiado quebradizo.

¡No tiene por qué quedar bonito! Sólo tienes que eliminar el recubrimiento suficiente para que los cables se asienten correctamente en sus conectores.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0