crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Scollegamento scheda madre

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:02crwdne2931653:0
Motherboard Disconnection, Remove the coating: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Motherboard Disconnection, Remove the coating: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Motherboard Disconnection, Remove the coating: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Remove the coating

  • Use the tip of a spudger to scrape the coating along the ZIF connectors' black locking tabs—enough so you can grab clumps of it with pointed tweezers.

  • Use pointed tweezers to peel off the coating around the black locking tabs and their hinges on the ZIF connector.

  • If the coating becomes too brittle and hard to peel off, reheat the connectors and try again.

  • This is a meticulous process! Failure to remove enough of the coating could damage the locking tab during disconnection, so take your time!

Rimuovi il rivestimento

Usa la punta di uno spudger per grattar via il rivestimento lungo le linguette di bloccaggio nere dei connettori ZIF, abbastanza da poter afferrarne dei pezzi con delle pinzette a punta.

Usa delle pinzette a punta per rimuovere il rivestimento intorno alle linguette di bloccaggio nere e le loro cerniere sul connettore ZIF.

Se il rivestimento diventa troppo friabile e difficile da rimuovere, scalda di nuovo i connettori e riprova.

Questo è un processo meticoloso! Non riuscire a rimuovere abbastanza rivestimento potrebbe danneggiare la linguetta di bloccaggio durante la sconnessione, quindi non avere fretta!

[title] Remove the coating
-[* black] Use the tip of a spudger to scrape the coating along the ZIF connectors' black locking tabs—enough so you can grab clumps of it with pointed [product|IF145-020|tweezers].
+[* black] Use the tip of a spudger to scrape the coating along the ZIF connectors' black locking tabs—enough so you can grab clumps of it with [product|IF145-020-2|pointed tweezers].
[* black] Use pointed tweezers to peel off the coating around the black locking tabs and their hinges on the ZIF connector.
[* icon_note] If the coating becomes too brittle and hard to peel off, reheat the connectors and try again.
[* icon_caution] This is a meticulous process! Failure to remove enough of the coating could damage the locking tab during disconnection, so take your time!

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0