crwdns2933423:0crwdne2933423:0

Steam Deck OLED 右側トリガーの交換

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:01crwdne2931653:0
Steam Deck OLED Right Trigger Replacement, Remove the right trigger: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Steam Deck OLED Right Trigger Replacement, Remove the right trigger: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Steam Deck OLED Right Trigger Replacement, Remove the right trigger: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Remove the right trigger
  • The right trigger is on your left-hand side when working on the Steam Deck OLED, as it's laying upside down.

  • The trigger clips into place on two pegs on the frame, which double as the hinge.

  • Place the flat end of a spudger onto the inside edge of the trigger's right clip.

  • Use your fingers to push the trigger toward the right as you wedge the spudger between the clip and the peg.

  • Use your spudger to pivot the trigger clip out, away, and up from the peg to unlatch it.

  • During reassembly, latch the left peg first. Once in place, push down on the trigger to latch the right peg, producing an audible "click" sound.

  • Check to make sure that the trigger spring is properly aligned. Test the trigger action before continuing reassembly.

スチームデッキOLEDを逆さまに配置すると、右側トリガーが左手にあります。

トリガーは、ヒンジを兼ねたフレーム上の2つのペグにクリップで固定します。

スパッジャーの平面側先端を、トリガーの右側クリップの内側の端に当てます。

指でトリガーを右方向に押しながら、スパッジャーをクリップとペグの間に挟みます。

スパッジャーを使って、トリガークリップをペグから離して、上に回転させながらラッチを外します。

再組み立ての際は、まず左側のペグを装着します。カチッという音がしたら、トリガーを押し込み、右側のペグを装着します。

トリガースプリングが正しく配置されていることを確認します。再組み立てを続ける前に、トリガーの動作をテストします。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0