crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Polaroid I-2 Rückabdeckung ausbauen

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:07crwdnd2931529:0crwdne2931529:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:08crwdne2931653:0
Polaroid I-2 Back Cover Removal, Reposition the back cover: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Polaroid I-2 Back Cover Removal, Reposition the back cover: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Polaroid I-2 Back Cover Removal, Reposition the back cover: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Reposition the back cover

  • Don't try to pull the back cover off just yet, as it's still connected by a cable.

  • At this point, the back cover should feel loose. If any parts still feel connected, repeat the last four steps until all the clips release.

  • Pull the back cover off the camera and rotate it over the right edge to expose the flex cable.

  • During reassembly, make sure the the flex cable isn't caught between the covers before re‑engaging the clips.

Rückabdeckung versetzen

Versuche noch nicht, die Rückabdeckung zu entfernen, da sie noch über ein Kabel verbunden ist.

Die Rückabdeckung sollte sich jetzt lose anfühlen. Wenn noch irgendwelche Teile fest sitzen, wiederhole die letzten vier Schritte, bis alle Clips gelöst sind.

Ziehe die Rückabdeckung von der Kamera ab und drehe sie über die rechte Kante, um das Flachbandkabel freizulegen.

Achte beim Wiederzusammenbau darauf, dass das Flachbandkabel nicht zwischen den Abdeckungen eingeklemmt ist, bevor du die Clips wieder einrasten lässt.

[title] Reposition the back cover
[* icon_caution] Don't try to pull the back cover off just yet, as it's still connected by a cable.
[* icon_note] At this point, the back cover should feel loose. If any parts still feel connected, repeat the last four steps until all the clips release.
[* black] Pull the back cover off the camera and rotate it over the right edge to expose the flex cable.
-[* icon_reminder] During reassembly, make sure the the flex cable isn't caught between the covers before re-engaging the clips.
+[* icon_reminder] During reassembly, make sure the the flex cable isn't caught between the covers before re‑engaging the clips.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0