crwdns2933423:0crwdne2933423:0

Polaroid I-2 후면 커버 분리

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:07crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936325:0crwdne2936325:0
crwdns2931653:04crwdne2931653:0
Polaroid I-2 Back Cover Removal, Insert an opening pick: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Polaroid I-2 Back Cover Removal, Insert an opening pick: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Polaroid I-2 Back Cover Removal, Insert an opening pick: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Insert an opening pick
  • Releasing the clips requires getting a tool between the covered "thin" edge of the front cover and the clips themselves.

  • Angle an opening pick upward and insert it at the gap where the bottom right corner of the back cover meets the triangular tip of the front cover’s right edge.

  • Push the pick up to get it above the overhanging lip in the back cover.

  • You'll see the plastic warp a little. This is normal.

  • While pushing upward, slowly rotate the pick towards the left edge of the camera until it's under the front cover.

  • The pick can slip out easily, so this may take a few tries.

클립을 해제하려면 전면 커버의 덮인 "얇은" 가장자리와 클립 사이에 도구를 끼워야 합니다.

여는 픽을 위쪽으로 기울여 후면 커버의 오른쪽 하단 모서리와 전면 커버 오른쪽 가장자리의 삼각형 끝이 만나는 틈에 끼우세요.

픽을 밀어 후면 커버의 돌출된 립 위로 올리세요.

플라스틱은 약간 휘어지지만 이것은 정상입니다.

픽을 위쪽으로 밀면서 카메라의 왼쪽 가장자리 방향으로 천천히 돌려 전면 커버 아래에 위치하도록 하세요.

픽이 쉽게 빠질 수 있으므로 몇 번 시도해야 할 수 있습니다.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0