crwdns2933423:0crwdne2933423:0

Extracción de la tapa trasera de Polaroid I-2

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:07crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:04crwdne2931653:0
Polaroid I-2 Back Cover Removal, Insert an opening pick: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Polaroid I-2 Back Cover Removal, Insert an opening pick: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Polaroid I-2 Back Cover Removal, Insert an opening pick: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Insert an opening pick
  • Releasing the clips requires getting a tool between the covered "thin" edge of the front cover and the clips themselves.

  • Angle an opening pick upward and insert it at the gap where the bottom right corner of the back cover meets the triangular tip of the front cover’s right edge.

  • Push the pick up to get it above the overhanging lip in the back cover.

  • You'll see the plastic warp a little. This is normal.

  • While pushing upward, slowly rotate the pick towards the left edge of the camera until it's under the front cover.

  • The pick can slip out easily, so this may take a few tries.

Para soltar los clips debes introducir una herramienta entre el borde "fino" cubierto de la tapa frontal y los propios clips.

Inclina una púa de apertura hacia arriba e insértala en el hueco donde la esquina inferior derecha de la contraportada se une con la punta triangular del borde derecho de la contraportada.

Empuja la púa hacia arriba para que quede por encima del reborde saliente de la tapa trasera.

Verás que el plástico se deforma un poco. Es normal.

Mientras empujas hacia arriba, gira lentamente la púa hacia el borde izquierdo de la cámara hasta que quede debajo de la tapa frontal.

La púa puede salirse con facilidad, por lo que es posible que haya que intentarlo varias veces.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0