crwdns2933423:0crwdne2933423:0

Sostituzione case posteriore con sportello pellicola Polaroid I-2

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:03crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:06crwdne2931653:0
Polaroid I-2 Back Cover Removal with Film Door Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Polaroid I-2 Back Cover Removal with Film Door Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Polaroid I-2 Back Cover Removal with Film Door Replacement: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
  • Angle a second opening pick upward and insert it at the gap where the bottom left corner of the back cover meets the triangular tip of the front cover’s left edge.

  • Push the pick up to get it above the overhanging lip in the back cover.

  • You'll see the plastic warp a little. This is normal.

  • While pushing upward, slowly rotate the pick towards the right edge of the camera until it's under the front cover.

  • The pick can slip out easily, so this may take a few tries.

Inclina un secondo plettro verso l'alto e inseriscilo nella fessura dove l'angolo inferiore sinistro incontra la punta triangolare del bordo sinistro del case anteriore.

Spingi il plettro verso l'alto per farlo arrivare sopra il margine che sporge nel case posteriore.

La plastica si deformerà un po'. È normale.

Mentre spingi verso l'alto, ruota leggermente il plettro verso il bordo destro della macchina fotografica finché non è sotto il case anteriore.

Il plettro può scivolare fuori facilmente, quindi potrebbero volerci più tentativi.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0