crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Polaroid I-2 unteres Gehäuse tauschen

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:015crwdnd2931529:0crwdne2931529:0

crwdns2935421:0crwdne2935421:0

crwdns2935425:09crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:09crwdne2931653:0
Polaroid I-2 Bottom Cover Replacement, Remove the bottom cover: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Polaroid I-2 Bottom Cover Replacement, Remove the bottom cover: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Polaroid I-2 Bottom Cover Replacement, Remove the bottom cover: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Remove the bottom cover

  • At this point, the bottom cover clips should be released. If not, slide an opening pick along the perimeter of the back cover to release any remaining clips.

  • Tilt the back of the bottom cover upward and pull it away from the camera, making sure to thread the film door lever from its recess.

  • Remove the back cover.

  • During reassembly, insert the film door lever into its recess before aligning the bottom cover and pressing it into place to secure its clips.

Unteres Gehäuse entfernen

Jetzt sollten die Clips des unteren Gehäuses gelöst sein. Ist dies nicht der Fall, schiebe ein Plektrum am Rand des unteren Gehäuses entlang, um die restlichen Clips zu lösen.

Kippe die Rückseite des unteren Gehäuses nach oben und ziehe es von der Kamera weg, wobei du darauf achten musst, dass du den Hebel der Filmklappe aus seiner Aussparung führst.

Entferne das untere Gehäuse.

Setze beim Wiederzusammenbau den Hebel der Filmklappe in seine Aussparung ein, bevor du das untere Gehäuse ausrichtest und festdrückst, um seine Clips zu verankern.

[title] Remove the bottom cover
-[* black] At this point, the bottom cover clips should be released. If not, slide an opening pick along the perimeter of the back cover to release any remaining clips.
+[* icon_note] At this point, the bottom cover clips should be released. If not, slide an opening pick along the perimeter of the back cover to release any remaining clips.
[* black] Tilt the back of the bottom cover upward and pull it away from the camera, making sure to thread the [link|https://guide-images.cdn.ifixit.com/igi/luEPUqFKF2sAO2Iq.full|film door lever|new_window=true] from its recess.
[* black] Remove the back cover.
[* icon_reminder] During reassembly, insert the film door lever into its recess before aligning the bottom cover and pressing it into place to secure its clips.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0