crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

移除主板

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:07crwdnd2931529:0crwdne2931529:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:013crwdne2931653:0
Logic Board Removal, Remove the front camera: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Logic Board Removal, Remove the front camera: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Logic Board Removal, Remove the front camera: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Remove the front camera

  • Use tweezers to grab the front camera by its connector, as close to the camera body as possible.

  • Don't pinch the press connector's pins, as you may bend them.

  • Pull straight up to separate the adhesive and remove the front camera.

  • During reassembly, if your adhesive is still intact and sticky, you can reuse it. Otherwise, follow this guide to replace the adhesive.

  • If you don't have custom cut adhesive strips, use double-sided tape, like Tesa Tape, to secure the front camera to the frame.

移除前镜头

使用镊子抓住前镜头的排线，尽量靠近镜头本身。

不要直接夹住接口，镊子可能会损坏接口内部的针脚。

向正上方拉起前镜头，分离粘胶，从机身中取出。

在重新组装时，如果粘胶没有缺损且仍有粘性，则可以重复使用。否则请参照此指南更换粘胶。

如果没有提前准备粘胶，可以使用双面胶带，例如Tesa Tape，将前镜头固定在机身边框上。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0