crwdns2933423:0crwdne2933423:0

Whirlpool Dryer Heizelement testen und tauschen

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:04crwdne2931653:0
Whirlpool Dryer Heating Element Testing and Replacement, Heater continuity check and ground check: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Whirlpool Dryer Heating Element Testing and Replacement, Heater continuity check and ground check: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Heater continuity check and ground check
  • (For three terminal heaters only) Check the resistance between the top and bottom terminals.

  • The multimeter should read about 40–50 Ω.

  • (All types) Check resistance from the each terminal to the heater housing.

  • The multimeter should read OL or "—"

  • If the element has the correct values when tested, you can stop here. You don't have to replace the heating element. As a precaution, while everything is accessible, you may want to test the components located on the heater housing.

  • For the hi limit thermostat/inlet thermistor combined component follow this link.

  • For the thermal cutoff switch, follow this link

(Nur bei Heizgeräten mit drei Kontakten) Überprüfe den Widerstand zwischen dem oberen und dem unteren Kontakt.

Das Multimeter sollte etwa 40-50 Ω anzeigen.

(Alle Typen) Überprüfe den Widerstand zwischen den einzelnen Kontakten und dem Gehäuse des Heizgeräts.

Das Multimeter sollte OL oder "-" anzeigen.

Wenn das Element bei der Prüfung die richtigen Werte aufweist, kannst du hier aufhören. Du brauchst das Heizelement nicht auszutauschen. Solange alles zugänglich ist, solltest du vorsichtshalber auch die Bauteile am Heizgerät prüfen.

Für das kombinierte Bauteil Thermostat, Temperaturregler und Einlass-Thermistor folge diesem Link.

Für den Wärmeschutzschalter, folge diesem Link.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0