Disasembling guide for Cabasse Swell

crwdns2936071:01crwdne2936071:0 — Remove end caps

Heat the speaker end caps with a hair dryer (low power) at a few centimeters distance to soften the adhesive.

crwdns2936071:02crwdne2936071:0 — Unscrew rings

Each ring is attached to the speaker body by 3 screws. Unscrew them. These rings hold the grilles recessed in the speaker body.

crwdns2936071:03crwdne2936071:0 — Remove grilles

Remove the 2 grilles that are inserted into the body of the speaker (there is no need to force).

crwdns2936071:04crwdne2936071:0 — Open the speaker

To access the inside of the speaker, you must unscrew, on the side where there are 3 membranes, the 4 screws at the ends (2 on each side, at the level of the active membranes) and the 4 screws of the passive membrane of the subwoofer.

crwdns2936071:05crwdne2936071:0 — Reassembling the speaker

Be sure to tighten each screw securely (but not too tightly) to avoid the speaker vibrating when listening to music with a lot of bass. Tightening it properly prevents this problem (in my experience).