crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

如何修复锡焊时的桥联缺陷

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:03crwdne2931653:0
How to Fix a Solder Bridge, Remove the solder bridge: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 How to Fix a Solder Bridge, Remove the solder bridge: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Remove the solder bridge

  • With the solder wick on top of the solder bridge, heat the wick using the soldering iron by pressing on top of the affected area.

  • The solder wick will be very hot! Avoiding touching the area of the wick near the soldering iron.

  • Alternatively, use wire cutters to cut off about 2 cm (0.75") of braid. Use tweezers or needle nose pliers to place it as described above.

  • Continue to apply pressure with the soldering iron to the solder bridge until the solder is melted and absorbed by the wick.

  • A soldering flux can also be used here to aid in the desoldering process by reducing oxide films.

清除桥联点

将吸锡带盖在桥联点上，并用电烙铁按住加热。

注意：吸锡带的受热部分温度极高，手持时应远离受热部分。

或者，也可以剪下2cm（约0.75英寸）左右的吸锡带用镊子或者尖嘴钳放到桥联点上使用。

保持对吸锡带施加压力，直到下边桥联点的焊锡受热熔化并被吸锡带吸干净。

在此步骤使用助焊膏可有助于除去氧化膜，提升除锡效率。

-[* black] Place the solder wick on top of the solder bridge and heat the wick using the soldering iron by pressing on top of the affected area.
+[title] Remove the solder bridge
+[* black] With the solder wick on top of the solder bridge, heat the wick using the soldering iron by pressing on top of the affected area.
[* icon_caution] The solder wick will be very hot! Avoiding touching the area of the wick near the soldering iron.
[* icon_note] Alternatively, use wire cutters to cut off about 2 cm (0.75") of braid. Use [product|IF145-020|tweezers] or needle nose pliers to place it as described above.
[* black] Continue to apply pressure with the soldering iron to the solder bridge until the solder is melted and absorbed by the wick.
[* icon_note] A soldering flux can also be used here to aid in the desoldering process by reducing oxide films.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0