How to Remove the Front Bulkhead of Your Whirlpool WED87HED

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:012crwdnd2931529:0crwdne2931529:0

crwdns2935421:0crwdne2935421:0 crwdns2935423:0crwdne2935423:0

crwdns2935425:010crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936321:0crwdne2936321:0

crwdns2931653:010crwdne2931653:0

How to Remove the Front Bulkhead of Your Whirlpool WED87HED, Release the belt tension: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

How to Remove the Front Bulkhead of Your Whirlpool WED87HED, Release the belt tension: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

How to Remove the Front Bulkhead of Your Whirlpool WED87HED, Release the belt tension: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Release the belt tension

Take careful note of the belt path before proceeding.
Be very careful during this step! The idler arm is under spring tension and may pinch you, or it could damage the belt switch if the arm is allowed to snap down.
Push the idler arm (the metal upside-down "L") up to relieve the tension on the drive belt.
Remove the belt from the motor pulley.
Gently lower the idler arm until it rests parallel to the dryer floor.
During reassembly, refer to your notes or the belt path link to rethread the drive belt.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0