crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Cómo retirar el panel trasero de tu secadora Whirlpool WED87HED

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:018crwdnd2931529:0crwdne2931529:0

crwdns2935421:0crwdne2935421:0

crwdns2935425:06crwdne2935425:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:06crwdne2931653:0
How to Remove the Rear Panel of Your Whirlpool WED87HED Dryer, Reassembly information: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 How to Remove the Rear Panel of Your Whirlpool WED87HED Dryer, Reassembly information: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Reassembly information

  • During reassembly, perform the following:

  • Make sure that the vent pipe is fitted into the collar on the panel.

  • Make sure the tabs at the bottom are aligned to the bottom rim of the chassis.

  • Position the panel so its screw holes match with the chassis.

Información de reensamblaje

Durante el reensamblaje, realiza lo siguiente:

Asegúrate de que el tubo de ventilación encaja en el collar del panel.

Asegúrate de que las pestañas de la parte inferior están alineadas con el borde inferior del chas

Coloca el panel de modo que sus orificios para tornillos coincidan con los del chasis.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0