crwdns2933423:0crwdne2933423:0

Whirlpool WED87HED Trockner Rückabdeckung ausbauen

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:018crwdnd2931529:0crwdne2931529:0

crwdns2935425:06crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
crwdns2931653:06crwdne2931653:0
How to Remove the Rear Panel of Your Whirlpool WED87HED Dryer, Reassembly information: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 How to Remove the Rear Panel of Your Whirlpool WED87HED Dryer, Reassembly information: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Reassembly information
  • During reassembly, perform the following:

  • Make sure that the vent pipe is fitted into the collar on the panel.

  • Make sure the tabs at the bottom are aligned to the bottom rim of the chassis.

  • Position the panel so its screw holes match with the chassis.

Beim Wiederzusammenbau musst du Folgendes beachten:

Vergewissere dich, dass das Entlüftungsrohr in den Kragen an der Abdeckung eingepasst ist.

Vergewissere dich, dass die Laschen an der Unterseite mit dem unteren Rand des Gehäuses übereinstimmen.

Richte die Abdeckung so aus, dass ihre Schraubenlöcher mit dem Gehäuse übereinstimmen.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0