crwdns2933423:0crwdne2933423:0

Procedura di apertura

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:010crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:012crwdne2931653:0
Opening Procedure, Separate the right edge adhesive: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Opening Procedure, Separate the right edge adhesive: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Opening Procedure, Separate the right edge adhesive: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Separate the right edge adhesive
  • The right edge of the iPad contains the screen magnets, display cables, and a digitizer cable. These components are easily damaged if an opening pick is inserted too far.

  • Insert a new opening pick in the bottom right corner and slide along the right edge to separate the adhesive. Make sure to note the following marked areas:

  • Don't insert an opening pick more than 2 mm or you'll damage the screen magnets.

  • The screen magnets are located directly above the SIM card slot (Wi-Fi + Cellular models only) and volume buttons.

  • Don't insert an opening pick more than 3 mm or you'll damage the display and digitizer cables.

  • Don't insert an opening pick more than 5 mm or you'll damage the display edges.

  • Leave the pick in the top right corner to prevent the adhesive from re-sealing.

Il bordo destro dell'iPad contiene i magneti dello schermo, i cavi del display e un cavo digitalizzatore. Questi componenti si danneggeranno facilmente se il plettro viene inserito troppo in profondità.

Inserisci un nuovo plettro di apertura nell'angolo in basso a destra e fallo scorrere lungo il bordo destro per separare l'adesivo. Accertati di fare attenzione nelle aree evidenziate:

Non inserire il plettro per più di 2 mm o danneggerai i magneti dello schermo.

I magneti dello schermo sono posizionati direttamente sopra lo slot della scheda SIM (solo per i modelli Wi-Fi + dati) e i pulsanti del volume.

Non inserire il plettro per più di 3 mm o danneggerai lo schermo e i cavi digitalizzatori.

Non inserire il plettro più di 5 mm o danneggerai i bordi del display.

Lascia il plettro sotto l'angolo in alto a destra per evitare che l'adesivo si rincolli.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0