crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

屏幕与外壳分离步骤

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:010crwdnd2931529:0crwdne2931529:0

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936311:0crwdne2936311:0
crwdns2931653:014crwdne2931653:0
Opening Procedure, Separate the top edge adhesive: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Opening Procedure, Separate the top edge adhesive: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Opening Procedure, Separate the top edge adhesive: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Separate the top edge adhesive

  • The top edge of the iPad contains the front camera module and two ambient light sensors. These components are easily damaged if an opening pick is inserted too far.

  • The two ambient light sensors can be hard to see and can be located using a flashlight or by placing the iPad under a bright light.

  • Insert a new opening pick in the top right corner and slide along the top edge to separate the adhesive. Make sure to note the following:

  • Don't insert an opening pick more than 5 mm or you'll damage the display edges.

  • Don't insert an opening pick more than 3 mm or you'll damage the ambient light sensors.

  • Don't insert an opening pick more than 2 mm or you'll damage the front camera module.

  • Leave the pick in the top left corner to prevent the adhesive from re-sealing.

分离上边缘屏幕与外壳

平板的上边缘包含相机模块和两个环境光传感器。如果撬片插得太深，这些部件就很容易被损坏。

这两个环境光传感器很难直接看见，可以用闪光灯或者将平板放在强光下来定位它们。

在屏幕右上角插入一个新撬片，其中一个插入的撬片沿上边缘滑动来分离屏幕和外壳。保证注意以下事项：

撬片插入深度不要超过五毫米，否则就会损伤显示器边缘。

撬片插入深度不要超过三毫米，否则就会损伤环境光传感器。

撬片插入深度不要超过两毫米，否则就会损伤相机模块。

将一个撬片留在平板上边缘的左端以避免屏幕和外壳重新闭合。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0