crwdns2933423:0crwdne2933423:0

開腹方法

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:010crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:014crwdne2931653:0
Opening Procedure, Separate the top edge adhesive: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Opening Procedure, Separate the top edge adhesive: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Opening Procedure, Separate the top edge adhesive: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Separate the top edge adhesive
  • The top edge of the iPad contains the front camera module and two ambient light sensors. These components are easily damaged if an opening pick is inserted too far.

  • The two ambient light sensors can be hard to see and can be located using a flashlight or by placing the iPad under a bright light.

  • Insert a new opening pick in the top right corner and slide along the top edge to separate the adhesive. Make sure to note the following:

  • Don't insert an opening pick more than 5 mm or you'll damage the display edges.

  • Don't insert an opening pick more than 3 mm or you'll damage the ambient light sensors.

  • Don't insert an opening pick more than 2 mm or you'll damage the front camera module.

  • Leave the pick in the top left corner to prevent the adhesive from re-sealing.

iPadの上端には、フロントカメラ・モジュールと2つの環境光センサーが搭載されています。これらの部品は、オープニングピックを挿入しすぎると簡単に破損しますので、ご注意ください。

2つの環境光センサーは見えにくいため、懐中電灯を使うか、iPadを明るい光の下で作業を進めると、位置を特定しやすくなりますで。

新しいオープニングピックを右上隅に挿入し、上端に沿ってスライドさせて接着剤を切り離します。以下の点に注意してください。

ディスプレイ端を破損しないように、5mm以上のピックを挿入しないでください。

環境光センサーを破損しないように、3mm以上、ピックを挿入しないでください。

フロントカメラモジュールを破損しないように、2mm以上、ピックを挿入しないでください。

接着剤の再装着を防ぐため、左上コーナーにピックを残します。

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0