crwdns2933423:0crwdne2933423:0

Procedura di apertura

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:010crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:014crwdne2931653:0
Opening Procedure, Separate the top edge adhesive: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Opening Procedure, Separate the top edge adhesive: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Opening Procedure, Separate the top edge adhesive: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Separate the top edge adhesive
  • The top edge of the iPad contains the front camera module and two ambient light sensors. These components are easily damaged if an opening pick is inserted too far.

  • The two ambient light sensors can be hard to see and can be located using a flashlight or by placing the iPad under a bright light.

  • Insert a new opening pick in the top right corner and slide along the top edge to separate the adhesive. Make sure to note the following:

  • Don't insert an opening pick more than 5 mm or you'll damage the display edges.

  • Don't insert an opening pick more than 3 mm or you'll damage the ambient light sensors.

  • Don't insert an opening pick more than 2 mm or you'll damage the front camera module.

  • Leave the pick in the top left corner to prevent the adhesive from re-sealing.

Il bordo superiore dell'iPad contiene il modulo della fotocamera interna e due sensori di luce ambientale.

I due sensori di luce ambientale possono essere difficili da vedere e possono essere localizzati usando una torcia o posizionando l'iPad sotto una luce luminosa.

Inserisci un nuovo plettro di apertura sotto l'angolo in alto a destra e fallo scorrere lungo il bordo superiore per separare l'adesivo. Fai attenzione alle aree evidenziate:

Non inserire il plettro per più di 5 mm o danneggerai i bordi del display.

Non inserire il plettro più di 3 mm o danneggerai i sensori di luce ambientale.

Non inserire il plettro per più di 2 mm o danneggerai il modulo della fotocamera interna.

Lascia il plettro nell'angolo in alto a sinistra per evitare che l'adesivo si rincolli.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0