crwdns2933423:0crwdne2933423:0

Procedura di apertura

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:010crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:07crwdne2931653:0
Opening Procedure, Insert an opening pick: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Opening Procedure, Insert an opening pick: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Opening Procedure, Insert an opening pick: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Insert an opening pick
  • If your screen is badly cracked, covering it with a layer of clear packing tape may allow the suction cup to adhere. Alternatively, very strong tape may be used instead of the suction cup. If all else fails, you can superglue the suction cup to the broken screen.

  • Apply a suction handle to the top left edge of the screen.

  • Pull up on the suction handle with firm, constant pressure to create a gap just small enough to insert an opening pick.

  • Only create a gap small enough to insert an opening pick. Overbending the screen will damage it.

  • Insert the tip of an opening pick into the gap.

  • Don't insert the opening pick more than 3 mm or you'll damage the display edges.

  • Leave the pick in to prevent the adhesive from re-sealing.

Se il tuo schermo ha molte crepe, coprirlo con uno strato di nastro adesivo trasparente da pacchi può aiutare a far fare presa alla ventose. In alternativa, puoi usare del nastro adesivo molto resistente invece della ventosa. Se tutto il resto fallisce, puoi incollare la ventosa con allo schermo rotto con della supercolla (cianoacrilica).

Applica una ventosa al bordo superiore dello schermo.

Tira la ventosa con forza decisa e costante per creare una fessura grande quanto basta per inserire un plettro di apertura.

La fessura dev'essere grande giusto quanto necessario per inserire il plettro. Lo schermo si danneggerà se piegato troppo.

Inserisci la punta di un plettro di apertura nella fessura.

Non inserire il plettro più di 3 mm o danneggerai i bordi del display.

Lascia il plettro inserito per evitare che l'adesivo si rincolli.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0