crwdns2933423:0crwdne2933423:0

Sostituzione Strisce Adesive iMac Intel 27" EMC 2546

crwdns2931527:0crwdnd2931527:0crwdnd2931527:0crwdnd2931527:0crwdne2931527:0

crwdns2936315:0crwdne2936315:0
crwdns2936321:0crwdne2936321:0
crwdns2931653:02crwdne2931653:0
iMac Intel 27" EMC 2546 Adhesive Strips Replacement: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 iMac Intel 27" EMC 2546 Adhesive Strips Replacement: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
  • Before you start placing strips, remove all of the old adhesive from around the perimeter of the rear enclosure.

  • If you are re-using your existing display, you must also remove the old adhesive from the back of the display.

  • Peel off the old strips of adhesive using tweezers or your fingers. Start at the bottom and peel upward towards the top of the device.

  • After all the old adhesive is removed, carefully clean the area under the adhesive with 90% (or greater) isopropyl alcohol and a lint-free cloth. Wipe in one direction, not back and forth.

  • Don't skip this step, or your new adhesive strips may not bond properly, and the display may fall out of your iMac.

Prima di attaccare le strisce adesive, bisogna rimuovere ogni residuo di adesivo intorno al perimetro del case posteriore.

Se si sta usando il display originale, bisogna rimuovere l'adesivo anche dal retro del display.

Rimuovi le strisce di adesivo vecchie usando delle pinzette o le dita. Inizia dal fondo e rimuovere verso l'alto fino alla fine del dispositivo.

Dopo avere rimosso ogni residuo di adesivo, pulisci con cautela l'area sotto l'adesivo con alcol isopropilico ad alta concentrazione (oltre 90%) e un panno privo di lanugine. Passa in una sola direzione e non avanti e indietro.

Non saltare questo passo, altrimenti le strisce adesive potrebbero non aderire bene e il display potrebbe cadere fuori dall'iMac.

[* icon_caution] Before you start placing strips, remove all of the old adhesive from around the perimeter of the rear enclosure.
[* black] If you are re-using your existing display, you must also remove the old adhesive from the back of the display.
- [* black] Peel off the old strips of adhesive using tweezers or your fingers. Start at the bottom and peel ''upward'' towards the top of the device.
+ [* black] Peel off the old strips of adhesive using [product|IF145-020|tweezers] or your fingers. Start at the bottom and peel ''upward'' towards the top of the device.
[* black] After all the old adhesive is removed, carefully clean the area under the adhesive with 90% (or greater) isopropyl alcohol and a lint-free cloth. Wipe in one direction, not back and forth.
[* icon_caution] ***Don't skip this step***, or your new adhesive strips may not bond properly, and the display may fall out of your iMac.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0