crwdns2933423:0crwdne2933423:0

Jura J models motor drain valve into operation

crwdns2935425:03crwdne2935425:0

crwdns2936319:0crwdne2936319:0
crwdns2936315:0crwdne2936315:0
crwdns2931653:03crwdne2931653:0
Jura J Modelle Motor Drainageventil in Gang setzen: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0
  • Drehe den Anker des Motors und halte den Stift dabei fest. Prüfe, ob sich der Stift hin und her bewegt.

  • Wahrscheinlich ist die Blockade damit schon gelöst. Fette die Schnecke (und den Stift) wieder etwas ein. Stelle sie so, dass sie etwa 3 mm herausschaut.

  • Baue den Motor wieder zusammen und biege die Haltelaschen am Metallgehäuse wieder um, bis es fest sitzt.

Turn the armature of the motor while holding the pin. Check whether the pin moves back and forth.

This may already have released the blockage. Grease the worm (and the pin) again a little. Position it so that it protrudes about 3 mm.

Reassemble the motor and bend the retaining tabs on the metal housing until it is tight.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0