crwdns2894164:0crwdne2894164:0

crwdns2876698:0crwdnd2876698:0crwdnd2876698:0crwdnd2876698:02crwdnd2876698:0crwdne2876698:0

crwdns2876889:0crwdne2876889:0
crwdns2876922:0crwdne2876922:0
crwdns2894314:03crwdne2894314:0
This step is only required if you have an anti-glare display. If you have a glossy display, skip to step 12. Disconnect the Bluetooth cable by pulling the male end straight away from its socket.
  • This step is only required if you have an anti-glare display. If you have a glossy display, skip to step 12.

  • Disconnect the Bluetooth cable by pulling the male end straight away from its socket.

  • Pull the connector parallel to the face of the logic board, not straight up.

  • Use the flat end of a spudger to pry the Bluetooth antenna cable from its socket on the board.

crwdns2869027:0crwdne2869027:0

crwdns2869027:0crwdne2869027:0

crwdns2869027:0crwdne2869027:0

crwdns2869027:0crwdne2869027:0

crwdns2859191:0crwdnd2859191:0crwdnd2859191:0crwdnd2859191:0crwdne2859191:0