crwdns2933423:0crwdne2933423:0

iPhone 14 Plus Rückkameraeinheit tauschen

crwdns2935443:0crwdne2935443:0

= crwdns2915112:0crwdne2915112:0 = crwdns2861241:0crwdne2861241:0
crwdns2936315:0crwdne2936315:0
crwdns2936319:0crwdne2936319:0
    Use this guide to replace the rear-facing camera assembly in an iPhone 14 Plus.
    This guide was created using the ***A2886*** (international) model. If you're fixing a different iPhone 14 Plus model, there may be some visual discrepancies, but the procedure should be the same.
    ***Note***: On iOS 18 and newer, you can calibrate new, genuine camera modules using Apple's [link|https://support.apple.com/en-us/120579|Repair Assistant|new_window=true].
    You’ll need replacement adhesive to reattach the screen when reassembling the device. Your device will function normally, but will most likely lose its IP (Ingress Protection) rating.
      If possible, turn on your device and test your repair before installing new adhesive and resealing.
      Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.
      ***To reassemble your device, follow these instructions in reverse order.***
      After your repair, depending on the replacement part, you may be able to [link|https://support.apple.com/en-us/120579|calibrate it using Apple's Repair Assistant|new_window=true], available as of iOS 18. Update your device, navigate to Settings ***→*** General ***→***About ***→*** Parts & Service History, tap Restart & Finish Repair, and follow the onscreen prompts.
      Take your e-waste to an [[E-Waste|R2 or e-Stewards certified recycler|new_window=true]].
      Repair didn’t go as planned? Try some [[Troubleshooting Problems After a Repair|basic troubleshooting]], or ask our [link|https://www.ifixit.com/Answers/Ask/iPhone+14+Plus|Answers community] for help.

      crwdns2931349:0crwdne2931349:0

      crwdns2936071:01crwdne2936071:0 — Rückkameraeinheit abtrennen

      Heble die Stecker an den beiden Kabeln zur Rückkameraeinheit mit dem Spudger nach oben aus ihren Anschlüssen heraus und trenne sie ab.

      crwdns2936071:02crwdne2936071:0 — Rückkamereinheit losschrauben

      Entferne die drei 2,1 mm langen Kreuzschlitzschrauben, mit denen die Rückkameraeinheit befestigt ist.

      crwdns2936071:03crwdne2936071:0 — Rückkamereinheit hochhebeln

      Setze einen Spudger mit der Spitze unter die Oberkante der Rückkamereinheit.

      crwdns2936071:04crwdne2936071:0 — Rückkamereinheit entfernen

      Entferne die Rückkameraeinheit mit einer Pinzette oder deinen Fingern.

      crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0