crwdns2933423:0crwdne2933423:0

Reemplazo de cristal trasero de Xiaomi Redmi Note 11 Pro

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:06crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:02crwdne2931653:0
Xiaomi Redmi Note 11 Pro Rear Glass Replacement, Insert an opening pick: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Xiaomi Redmi Note 11 Pro Rear Glass Replacement, Insert an opening pick: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Xiaomi Redmi Note 11 Pro Rear Glass Replacement, Insert an opening pick: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Insert an opening pick
  • Secure a suction handle to the bottom edge of the rear glass, as close to the edge as possible.

  • If the rear glass is cracked, the suction handle may not stick. Try lifting it with strong tape, or superglue the suction handle in place and allow it to cure so you can proceed.

  • Lift the rear glass with the suction handle to create a small gap between the back cover and the frame.

  • If you're having trouble creating a gap, apply more heat to further soften the adhesive. Follow the iOpener instructions to avoid overheating.

  • Insert an opening pick into the gap you created.

  • Slide the opening pick to the bottom right corner to slice the adhesive.

  • Leave the opening pick in place to prevent the adhesive from resealing.

Aplica una ventosa a la esquina inferior del cristal trasero, tan cerca del borde como sea posible.

Si el cristal trasero está rajado, puede que la ventosa no se pegue correctamente. Intenta usar cinta adhesiva muy resistente para levantarlo o pega con la ventosa con superglue y tras dejar secar intenta proceder.

Levanta el cristal trasero usando el mango de la ventosa para crear un pequeño hueco entre la tapa trasera y la carcasa.

Si tienes problemas para crear un hueco, aplicar más calor para ablandar aún más el adhesivo. Sigue las instrucciones del iOpener para evitar sobrecalentamientos.

Inserta una púa de apertura en el hueco que has creado.

Desliza la púa de apertura a la esquina inferior derecha para separar el adhesivo.

Deja la púa de apertura donde está para evitar que el adhesivo se vuelva a pegar.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0