crwdns2933423:0crwdne2933423:0

Opening Procedure (1st and 2nd Gen)

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:08crwdnd2931529:0crwdne2931529:0

crwdns2936315:0crwdne2936315:0
crwdns2936325:0crwdne2936325:0
crwdns2931653:023crwdne2931653:0
Opening Procedure (1st and 2nd Gen), Unscrew the ambient light sensor cable bracket: crwdns2935265:00crwdnd2935265:01crwdnd2935265:02crwdne2935265:0 Opening Procedure (1st and 2nd Gen), Unscrew the ambient light sensor cable bracket: crwdns2935265:00crwdnd2935265:02crwdnd2935265:02crwdne2935265:0
Unscrew the ambient light sensor cable bracket
  • Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from.

  • Use a Phillips screwdriver to remove the two screws securing the ambient light sensor cable bracket to the logic board:

  • One 1.3 mm screw

  • One 2.0 mm screw

  • During reassembly, this is a good point to power on your iPad and test all functions before sealing it up. Be sure to power your iPad back down before you continue working.

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0