Replacing accessory belt and rollers

crwdns2936071:01crwdne2936071:0 — Remove the accessory belt protective cover

Remove the 4 screws from the belt protection cover using a 10mm wrench.

crwdns2936071:02crwdne2936071:0 — Release and remove the accessory belt

Our aim is to have a colored tensioner like the one shown in the picture and like the new tensioner.

crwdns2936071:03crwdne2936071:0 — Replacing the tensioner roller

Remove the single 13mm hexagonal screw from the tensioner and pull it out.

crwdns2936071:04crwdne2936071:0 — Replacing the winding roller

Use a screwdriver to remove the cap from the winding roller.

crwdns2936071:05crwdne2936071:0 — Replacing the accessory belt

The idler roller must be in the slack position and tapped. If this is not the case, refer to step 2 to adjust it.

crwdns2936071:06crwdne2936071:0 — Releasing the tensioner

Using a 13mm hex wrench, release the tensioner roller to remove the pin and return it to the tensioned position.

crwdns2936071:07crwdne2936071:0 — Replace belt cover

Replace the accessory belt cover and tighten the 4x 10mm screws to 10 N/m.