Opening Procedure

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:073crwdnd2931529:0crwdne2931529:0

crwdns2935421:0crwdne2935421:0 crwdns2935423:0crwdne2935423:0

crwdns2935425:020crwdne2935425:0

crwdns2935419:0crwdne2935419:0

crwdns2936315:0crwdne2936315:0

crwdns2936313:0crwdne2936313:0

crwdns2931653:020crwdne2931653:0

Opening Procedure, Separate the bottom adhesive: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0

Opening Procedure, Separate the bottom adhesive: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0

Opening Procedure, Separate the bottom adhesive: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0

Separate the bottom adhesive

Insert a new opening pick into the gap you just created on the bottom edge of the iPad.
Slide the pick over the antenna, stopping just before the home button.
Only slide the pick towards the home button and not away from it, as you may damage the antenna.
If you need to slide the pick over this section again, remove and re-insert it at the bottom-left corner.
Leave the pick to the left of the home button before continuing.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0