crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

4. Installing Klipper on SKR3 EZ

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:06crwdne2931653:0
4. Installing Klipper on SKR3 EZ: crwdns2935265:00crwdnd2935265:01crwdnd2935265:01crwdne2935265:0

  • SSH into your pi and run

  • cd ~/klipper

  • make menuconfig

  • Set the following parameters

  • Enable extra low-level configuration options

  • Micro-controller Architecture (STMicroelectronics STM32) --->

  • Processor model (STM32H743) --->

  • Bootloader offset (128KiB bootloader (SKR SE BX v2.0)) --->

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0