crwdns2933423:0crwdne2933423:0

Reemplazo de pantalla y batería de Wahoo Elemnt Roam (WFCC4)

crwdns2936315:0crwdne2936315:0
crwdns2936331:0crwdne2936331:0
crwdns2931653:014crwdne2931653:0
Wahoo Elemnt Roam (WFCC4) Screen and Battery Replacement, Solder Leads to Old Battery's Circuit Board: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Wahoo Elemnt Roam (WFCC4) Screen and Battery Replacement, Solder Leads to Old Battery's Circuit Board: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Wahoo Elemnt Roam (WFCC4) Screen and Battery Replacement, Solder Leads to Old Battery's Circuit Board: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Solder Leads to Old Battery's Circuit Board
  • Solder the positive and negative leads to the pads of the old battery's circuit board, which we prepared earlier

  • Please take note of the circuit board's and the ribbon cable's orientation. The ribbon cable has to run under the battery and then wrap around it, to ensure proper orientation with the connector on the mainboard

  • Wrap the circuit board in kapton tape and secure it closely to the battery, to create a tight and tidy package

  • Use a multimeter to check for voltage at the ribbon cable's end points, to check for a proper connection

Suelda los cables positivo y negativo a las almohadillas de la placa de circuito de la batería vieja, que preparamos anteriormente.

Toma nota de la orientación de la placa de circuito y del cable plano. El cable plano debe pasar debajo de la batería y luego enrollarse alrededor de ella para garantizar la orientación adecuada con el conector en la placa base.

Envuelve la placa de circuito con cinta Kapton y asegúrela firmemente a la batería para crear un paquete hermético y ordenado.

Utiliza un multímetro para verificar el voltaje en los puntos finales del cable plano y verificar que la conexión sea adecuada.

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0