crwdns2933423:0crwdne2933423:0

MacBook Pro 13インチ Touch Bar 2018 ロジックボード交換

crwdns2931529:0crwdnd2931529:0crwdnd2931529:0crwdnd2931529:07crwdnd2931529:0crwdne2931529:0

crwdns2935425:01crwdne2935425:0

crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:01crwdne2931653:0
MacBook Pro 13" Touch Bar 2018 Logic board Replacement, Disable Auto Boot: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 MacBook Pro 13" Touch Bar 2018 Logic board Replacement, Disable Auto Boot: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 MacBook Pro 13" Touch Bar 2018 Logic board Replacement, Disable Auto Boot: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Disable Auto Boot
  • Before starting this procedure, you must disable your Mac's Auto Boot feature. Auto Boot powers on your Mac when you open the lid, and may be accidentally triggered during disassembly. Use this guide or follow the abbreviated instructions below to disable Auto Boot. This command may not work on all Macs.

  • Power on your Mac and launch Terminal.

  • Copy and paste the following command (or type it exactly) into Terminal:

  • 'sudo nvram AutoBoot=%00

  • Press [return]. If prompted, enter your administrator password and press [return] again. Note: Your return key may also be labeled ⏎ or "enter."

  • You can now safely power down your Mac and open the bottom case, without it accidentally powering on.

  • When your repair is complete and your Mac is successfully reassembled, re-enable Auto Boot with the following command (typed into Terminal, as shown above):

  • sudo nvram AutoBoot=%03

この手順を開始する前に、Mac の自動ブート機能を無効にする必要があります。自動起動は、蓋を開けると Mac の電源をオンにしますが、分解中に誤って起動される可能性があります。自動ブートを無効にするには、このガイドを使用するか、以下の簡単な手順に従ってください。このコマンドはすべての Mac で機能するとは限りません。

Mac の電源を入れてターミナルを起動します。

次のコマンドをコピーしてターミナルに貼り付けます (または正確に入力します)。

'sudo nvram AutoBoot=%00

[戻る]を押します。プロンプトが表示されたら、管理者パスワードを入力し、もう一度 [return] を押します。注: リターン キーには、「⏎」または「enter」というラベルが付いている場合もあります。

これで、Mac の電源が誤ってオンになることなく、安全に Mac の電源を切り、下部ケースを開けることができます。

修復が完了し、Mac が正常に再組み立てされたら、次のコマンド (上記のようにターミナルに入力) で自動起動を再度有効にします。

sudo nvram AutoBoot=%03

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0