crwdns2933423:0crwdne2933423:0

Vorwerk Kobold VR200 battery exchange/removal

crwdns2935443:0crwdne2935443:0

= crwdns2915112:0crwdne2915112:0 = crwdns2861241:0crwdne2861241:0
crwdns2936319:0crwdne2936319:0
crwdns2936315:0crwdne2936315:0

      crwdns2931349:0crwdne2931349:0

      crwdns2936071:01crwdne2936071:0 — Turn off robot

      Turn off the robot via the "Settings" > "Turn off robot" menu.

      crwdns2936071:02crwdne2936071:0 — Turn the Robot

      Turn the robot over and place it on a suitable, soft surface. Make sure that the robot does not lie directly on the dome.

      crwdns2936071:03crwdne2936071:0 — Remove Torx Screws

      Now remove the two screws 3.5x14mm with a Torx screwdriver T10

      crwdns2936071:04crwdne2936071:0 — Remove Battery Cover

      Now pry open the battery cover with a suitable tool (plectrum or plastic opening tool). Make sure that there are two latches on the opposite side of the screws. The cover must therefore be lifted from the screw-on side.

      crwdns2936071:05crwdne2936071:0 — Remove the Battery

      Removing the battery is a bit difficult. One possibility is that you use the plastic opening tool to remove the foam tape on the left and right side of the battery.

      crwdns2936071:06crwdne2936071:0 — Disconnect the Battery

      Disconnect the 4-pin plug of the battery by first pressing the latch and then pulling out the plug.

      crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0