crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

Blackview BV9800 Pro Screen Replacement

crwdns2935419:0crwdne2935419:0
crwdns2936315:0crwdne2936315:0
crwdns2936323:0crwdne2936323:0
crwdns2931653:07crwdne2931653:0
Blackview BV9800 Pro Screen Replacement, Remove top PCB and plastic enclosure: crwdns2935265:00crwdnd2935265:01crwdnd2935265:03crwdne2935265:0 Blackview BV9800 Pro Screen Replacement, Remove top PCB and plastic enclosure: crwdns2935265:00crwdnd2935265:02crwdnd2935265:03crwdne2935265:0 Blackview BV9800 Pro Screen Replacement, Remove top PCB and plastic enclosure: crwdns2935265:00crwdnd2935265:03crwdnd2935265:03crwdne2935265:0
Remove top PCB and plastic enclosure

  • Heat up this PCB with either iOpener or a heat gun on low temp (100-120 Celsius) to loosen the adhesive and pry it off from the side.

  • Remove the screws.

  • The last screw is under a tamper-proof sticker

  • Use plastic spudger or tweezers to disconnect the camera flex cable from the top

  • Gently lift up the plasctic cover from the right side. It is still connected to the board below!

  • Disconnect the flex cable

  • Disconnect the antenna

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2935429:0crwdne2935429:0

crwdns2944171:0crwdnd2944171:0crwdnd2944171:0crwdnd2944171:0crwdne2944171:0